For a Bunn coffee maker, use a standard drip grind. Bunn's own home brewer manual calls for drip grind in its flat-bottom filters, and its manuals warn that fine-ground coffee can overflow grounds into the pot. Coarse grind tends to run through too fast and brew weak, and espresso grind is too fine for these machines.
That applies to most fast commercial and office drip brewers with a flat-bottom basket, Bunn or otherwise. Below is why grind matters so much in these machines and how to fix the two most common complaints: overflow and weak coffee. Bunn is a trademark of its owner; we are not affiliated with the company and are working only from its published documents.
What grind for a Bunn coffee maker? The short answer
- Use: standard drip grind.
- Avoid: espresso or very fine grind, which can slow drainage and overflow the basket.
- Use with care: coarse grind, which often under-extracts and gives a thin pot.
- Filters: the paper filters made for your brewer.
Why fast commercial brewers are picky about grind
Bunn-style brewers are built for speed. Hot water is held ready in a tank and sprayed over the grounds as soon as you start a brew. The Bunn BX manual describes a standard three-minute brew cycle and says that grounds exposed to water for more than six minutes can taste bitter from over-extraction.
A short cycle leaves little room for error. Bunn's Coffee Basics guide states the rule simply: the finer the grind, the shorter the time. Fine coffee gives up its flavor quickly; coarse coffee needs longer contact. The grind has to match the contact time the machine is built for, and for these brewers that is a drip grind.
The same guide also says total contact time should never go past eight minutes, recommends brewing water at 195 to 205°F, and calls for a coffee bed between one and two inches deep. A bed thinner than an inch can under-extract, and one deeper than two inches can over-extract and turn bitter.
Standard vs. coarse vs. espresso grind in a flat-bottom basket
| Grind | What happens in a fast drip brewer | Verdict |
|---|---|---|
| Standard (drip) | Water passes through at the rate the brewer is designed for | Use this |
| Coarse | Water runs through too quickly; the pot can come out weak or sour | Only if you add more coffee; better in a percolator or urn |
| Espresso | Packs down, slows drainage, can flood the basket and leave grounds in the pot | Do not use |
Fixing Bunn coffee maker grounds overflow
When a basket overflows or grounds end up in the pot, the water is coming in faster than it can drain. Common causes and fixes:
- Grind too fine. Bunn's BX manual lists fine-ground coffee as a cause of overflow. Switch to a standard drip grind.
- Decaf or softened water. The same manual names decaffeinated coffee and softened water as other possible causes. It says Bunn customer service can supply a flow restrictor sprayhead at no charge to help.
- Wrong filters. The Bunn HG manual says its paper filters are taller, which keeps overflow and grounds out of the coffee. A filter that is too short or folded wrong can let grounds over the top.
- Too much coffee. An overfilled basket can block the flow. Keep the bed within the one to two inch range Bunn recommends.
- Clogged sprayhead. Mineral deposits can make water spray unevenly. Clean it as your manual describes.
Fixing weak coffee without changing the grind
If the grind is right but the pot is still weak:
- Use more coffee. This is the first fix to try. Add a little at a time until it tastes right.
- Check the bed depth. If the grounds are less than an inch deep, Bunn's guide says the coffee can under-extract.
- Check water temperature. If your brewer has a thermostat and the water is running below 195°F, extraction suffers. Follow the manual or call a service tech; do not guess at internal settings.
- Clean the sprayhead. Uneven spray can leave dry pockets of grounds.
- Use fresher coffee. Stale coffee brews flat however you grind it.
How much coffee per pot
For its home brewers, Bunn's HG manual suggests one to two heaping tablespoons of drip-grind coffee per cup for a full 40 oz pot, or about one to one and a half inches of coffee in the flat-bottom filter.
Bunn's Coffee Basics guide does not give a single recommended amount for commercial pots. It does show how strength rises with more coffee per half-gallon of water, and gives a target range for strength and extraction. In its example, four ounces of coffee per half-gallon came out on the strong side. Start with what your brewer's manual or coffee supplier suggests, then adjust by small amounts and keep the bed within one to two inches.
For a shop that runs pots all day, our guide to coffee for the shop break room covers how much to buy and how to keep it good.
Filters, water and cleaning that affect taste
- Filters: Bunn's Coffee Basics guide says paper filters give the clearest cup. Use the size and shape made for your basket.
- Water: hard water leaves mineral deposits. Bunn's guide says to keep the sprayhead, funnel, servers and reservoir free of lime and scale.
- Holding: the same guide puts holding time at about 20 minutes in an open decanter, or about an hour in a closed container. After that, brew fresh.
- Cleaning: Bunn's guide warns against steel wool and other abrasives, which can scratch surfaces and lead to more deposits.
Which grind to order
For a Bunn or any flat-bottom drip brewer, order a standard grind. Night Call House Blend comes in standard, coarse or espresso grind, or whole bean; the standard grind is the one for these brewers, and the espresso grind is not meant for them. Shops buying in bulk can see our page for shops.