What class safety vest do tow truck drivers need? For work in the roadway, generally high-visibility apparel that meets Performance Class 2 or Class 3 of the ANSI/ISEA 107 standard, the level the federal traffic control manual sets for workers in the right-of-way. Class 3 carries more high-visibility material, which makes it a sensible pick for night, highway and bad-weather calls. Your state, your rotation list or your insurer can ask for more, so check with them before you buy a stack of vests.
General information, not legal advice. We checked the sources below in November 2026.
What class safety vest do tow truck drivers need? The short answer
- Look for a garment labeled as meeting ANSI/ISEA 107, Performance Class 2 or Class 3.
- Class 3 carries more fluorescent and reflective material than Class 2, which counts on highways and in low light.
- Type R garments are built for roadway work; Type P garments are aimed at public safety and incident responders. Either can be acceptable under federal guidance, discussed below.
- Do not assume one class satisfies every rule everywhere. Confirm with your state, your rotation or police contract, and your insurer.
Where the rule comes from: MUTCD and ANSI/ISEA 107
Two documents do most of the work. The first is the Manual on Uniform Traffic Control Devices, published by the Federal Highway Administration. The current edition, the 11th Edition with Revision 1, covers apparel in Section 6C.05, High-Visibility Safety Apparel. In plain terms, it says all workers within the right-of-way who are within a temporary traffic control (TTC) zone, emergency responders included, must wear high-visibility apparel, day and night, meeting Performance Class 2 or 3 of ANSI/ISEA 107-2015 or equivalent revisions, with the class chosen by the employer's designated safety person. It also sets the colors: fluorescent orange-red, fluorescent yellow-green or a mix for the background, plus retroreflective material in approved colors.
The second is ANSI/ISEA 107 itself, the industry standard that defines the classes and types.
Section numbers moved when the 11th Edition replaced the 2009 edition. Older letters and policy PDFs cite Sections 6D.03, 6E.02 and 7D.04 from the 2009 manual. If a state document quotes those numbers, it is pointing at the earlier edition.
There is also a federal rule behind all this. FHWA's Worker Visibility rule, published in the Federal Register on November 24, 2006 (23 CFR Part 634), required workers on foot in the right-of-way of a Federal-aid highway to wear Class 2 or 3 apparel, with compliance due by November 24, 2008. Its list of covered workers includes incident responders. The rule does not name tow operators specifically.
ANSI Class 2 vs. Class 3 vest in plain terms
The classes are mostly about how much high-visibility material a garment carries. The standard itself is sold, not posted free, so we are not quoting it. A summary table posted by the South Dakota DOT, covering the 2004 edition, shows the gap (the sheet notes it is a summary, not an official interpretation):
| Minimum material (2004 edition) | Class 2 | Class 3 |
|---|---|---|
| Fluorescent background | 775 sq in | 1,240 sq in |
| Retroreflective material | 201 sq in | 310 sq in |
| Minimum reflective stripe width | 1.375 in | 2 in |
Later editions reorganized the standard, so treat those figures as a picture of the difference rather than a spec to buy against; the label on the garment is what counts. The point for a tow scene is simple: more material means you show up sooner and from farther away, especially in headlights. That is a good reason to consider Class 3 as the shop standard for highway calls, even where Class 2 would pass.
Type R vs. Type P safety vest
The 2015 edition of ANSI/ISEA 107 sorted garments into types. Type R is for roadway workers. Type P is the public safety type, aimed at emergency responders.
FHWA addressed this in Official Interpretation 6(09)-37(I), dated June 1, 2016. It said Type R Class 2 and 3 garments match the earlier Class 2 and 3 garments, Type P Class 2 matches the earlier public safety vest, Type P Class 3 is a new option for emergency responders, and garments meeting the 2015 standard comply with Sections 6D.03, 6E.02 and 7D.04 of the 2009 manual. The current manual also lets emergency and incident responders wear vests labeled to the older ANSI/ISEA 207-2006 public safety vest standard.
For a tow operator, either type can work under that guidance. Pick the one whose cut lets you work a winch, chains and a wheel lift without the garment getting in the way, and confirm your rotation does not specify one.
State add-ons: the Texas example
States and contracts can go further than the federal manual. Texas is one example: its tow rules at 16 Tex. Admin. Code 86.1001 require towing operators to wear a reflective vest, shirt or jacket whenever they work outside the truck, and when they are using or helping with a licensed tow truck on a road, the garment must meet the ANSI/ISEA high-visibility requirements at all times. That page does not name a class.
Other states, cities and rotation programs have their own wording. The only way to know is to read your state's rules and your contract, and ask your insurer what it expects.
Night, rain and winter layers
The vest only works if it is the outer layer. A Class 3 vest zipped under a dark coat does nothing for you. A few habits help:
- Buy winter jackets and rain gear that carry their own ANSI/ISEA 107 label, rather than counting on a vest thrown over the top.
- Size vests to fit over your heaviest coat, so they actually get worn in January.
- Consider hi-vis pants for night highway work if your gear is otherwise dark below the waist.
- Keep a spare in the truck for when the first one gets soaked or muddy.
Buying checklist: label, fit, condition
- Label: Look for the ANSI/ISEA 107 marking with the type and performance class printed on it.
- Class: Class 2 at minimum for right-of-way work; Class 3 for highway and night work if you want margin.
- Fit: Over your bulkiest outer layer, without riding up when you bend to hook up.
- Condition: Faded, torn or grease-soaked fabric and cracked reflective tape are signs to replace. Follow the care and replacement guidance on the garment's label.
- Your rules: Confirm with your state, rotation list and insurer before you standardize on one vest for the crew.
For the bigger picture on staying visible on the shoulder, see our slow down, move over page. Shopping for someone in the trade? Our list of gifts for tow truck drivers has more ideas.