The right percolator coffee grind is coarse, about like coarse sand or kosher salt. A percolator pushes hot water up through the grounds over and over, so a fine grind over-extracts and slips through the basket into your cup. Pair a coarse grind with a short, gentle perk of several minutes, and most bitter pots get fixed.
Below is the reasoning, a starting dose, how to time it on a stove, a campfire or an electric unit, and what to change when the pot still comes out wrong.
The short answer on percolator coffee grind
- Grind: coarse. Particles you can see and feel individually, not powder.
- Dose: start around one level tablespoon of ground coffee per cup of water and adjust to taste.
- Time: on a stovetop or campfire, a gentle perk of roughly 6 to 10 minutes after the first bubbles show in the glass knob. On an electric model, follow the manual.
- Heat: keep it at a steady perk, not a hard boil.
Why percolators punish fine grounds
Most brewers pass water through coffee once. A percolator does not. Water heats in the bottom chamber, climbs the center stem, spills over the grounds in the basket, drains back down, and does it again for as long as the pot is on the heat. The brewed coffee is what keeps cycling, so the grounds get hit with hotter and stronger liquid each pass.
Fine grounds have far more surface area, so they give up their flavor fast. Under repeated passes, that turns into the harsh, bitter edge people associate with percolator coffee. Fine grounds also slip through the holes in the basket and end up as sludge at the bottom of the cup.
A coarse grind slows extraction enough that the repeated cycling works in your favor instead of against you, and the particles are too big to get through the basket. If you are not sure what counts as coarse, our guide to whole bean vs ground coffee covers grind sizes and when grinding your own makes sense.
How much coffee per cup of water
A good starting point is one level tablespoon of coarse ground coffee for each cup of water. Go by the cup markings on your pot rather than a kitchen measuring cup, since makers do not all define a cup the same way. From there:
- Too weak: add a little more coffee next time before you add more time.
- Too strong or harsh: use a little less coffee, or shorten the perk.
- Do not fill the basket past its line. Grounds need room to get wet evenly, and an overfilled basket can push grounds over the top.
Making 30 cups or more for a crew is a different job. For those amounts, see our chart on how much coffee for a 30 cup urn.
Timing: when to start the clock and when to stop
The clock starts when the pot begins to perk, meaning you see coffee-colored water popping into the glass knob on the lid, not when you put it on the heat. Turn the heat down at that point so the perk stays steady and gentle.
A gentle perk of about 6 to 10 minutes is a common starting range. The reasoning is simple: every minute of perking is another round of hot coffee through the same grounds. Too short and the coffee is thin. Too long and it turns bitter. Watch the color in the knob. When it looks like coffee you would drink, pull it off.
Once it is off the heat, lift out the basket and stem if your pot allows it. Leaving the grounds in the pot lets them keep steeping in the hot coffee.
Stovetop and campfire vs. electric
| Stovetop or campfire | Electric | |
|---|---|---|
| Who controls the heat | You do | The unit does |
| Timing | Start the clock at the first perk, then judge by color | Follow the manual; many shut off or switch to warm on their own |
| Main risk | Hard boil from too much heat | Holding on warm too long after brewing |
| Fix | Lower the flame or move to the edge of the coals | Pour off what you will not drink soon |
On a campfire or a deer-camp stove, heat is hard to manage. Set the pot on a grate at the edge of the fire rather than in the middle, and move it farther out once it starts to perk.
Electric models are built to run the cycle themselves. Do not try to override the timing; follow the maker's instructions for amounts and leave the rest to the thermostat.
Fixing bitter, weak or gritty coffee
Bitter
- Grind coarser.
- Shorten the perk by a couple of minutes.
- Lower the heat so it perks rather than boils.
- Pull the basket as soon as it is done.
Weak
- Add more coffee before adding time.
- Check that the pot actually reached a perk. A stove set too low can leave water barely moving.
Gritty
- The grind is too fine for the basket.
- Paper disc filters made for percolator baskets can help catch fines. This is worth trying if you only have standard ground coffee on hand, though it will not turn a fine grind into a coarse one.
If you buy pre-ground for a percolator, order it coarse. Our Night Call House Blend comes in a coarse grind option for exactly this kind of brewer, as well as whole bean if you would rather grind it yourself.
Cleaning the stem and basket
Old coffee oils build up in a percolator and turn new pots stale and bitter. After each use:
- Dump the grounds and rinse the basket, stem and pot with hot water.
- Run a narrow brush through the stem, since it is the part that clogs.
- Check the small holes in the basket and spreader cover and clear any that are blocked.
- Let everything dry apart before you put it back together.
Every so often, give it a deeper clean with a mild cleaning solution made for coffee equipment, following the maker's directions. For electric units, never submerge the base; check the manual for what can go in water.